Die Beziehung zwischen dem Versiegelungsprozess der Blechdose und dem Material

Die Beziehung zwischen dem Versiegelungsprozess von Blechdosen und dem Material

How many layers can be rolled in theTin Cans sealing process? Some people think that more is more, and that's true! The more layers of crimping, the higher the strength and the better the sealing effect. However, is it possible to achieve ten or twenty layers of wrapping? Here we do not say that there is a quality cost problem, in fact, it is not possible to achieve.

1. It is conceivable that if the material of theTin Cans is made of spring steel, which is the same material as the law of a clock, not to mention ten layers of rolls, I am afraid that it is easy to roll twenty layers, because it has good elasticity and rigidity, and can be sealed through the outer rolls. The force is easily transmitted to the center. But this is impossible, because this material has good elasticity, so it is easy to rebound back to the original state after the end of the wrapping and the wrapping force disappears, that is to say, it returns to the beginning of the wrapping. This is obviously not what we need. Therefore, it is impossible for us to choose high elastic materials. As far as the materials used to makeTin Canss in the world are concerned, our country's materials are the most rigid, so it is difficult to guarantee the quality. And the number of curling layers does not exceed seven layers. According to the research of relevant foreign experts, the number of layers ofTin Cans curling will not exceed seven layers, obviously the curling force cannot be transmitted that far.

Die Begrenzung der Rohstoffe von Tin Canss Um Tin Canss herzustellen, muss der Kohlenstoffgehalt des Materials niedrig und die Plastizität besser sein. Aufgrund dieser guten Verarbeitungsleistung sind Schweißen, Stanzen und Ausbauchen einfach, um die Qualität sicherzustellen. Das Falzen ist jedoch anders, da sich die Größe der Falzrollenrille beim Falzvorgang nicht ändern kann und die Falzkraft allmählich durch das Umfangsmaterial auf die Mitte des Falzes übertragen werden muss, damit die Mitte gewalzt werden kann. Je besser die Plastizität des Materials ist, desto schwieriger ist die Kraftübertragung.